Knock Down Textured Ceilings

Whether you build new or remove the dated (and dreaded) popcorn ceilings, you can apply your own knockdown ceiling texture and save. Apr 11, 2020  Knock Down Ceiling Vs Smooth by Susan April 11, 2020 11 best ceiling texture types for southerntexturesfl wver your popcorn ceilings increase home value wall texture spray vs smooth.

Knockdown Texture is a drywall finishing style. It is a mottled texture, more intense than a simple flat finish, but less intense than orange peel, or popcorn, texture.

Knockdown texture is created by watering down joint compound to a soupy consistency. A trowel is then used to apply the joint compound. The joint compound will begin to form stalactites as it dries. The trowel is then run over the surface of the drywall, knocking off the stalactites and leaving the mottled finish.

A much more common, and faster technique is to apply the texture mud (which is slightly different from joint compound, in that it has less shrinkage upon drying) with a texture machine – a compressor and a texture spray hopper which sprays mud instead of paint. This applies what is referred to as a splatter coat. The use of a compressor allows this to be applied to walls as well as ceilings. When knocking this down, the mud is allowed to dry for a short period, then skimmed with a knockdown knife – a large, usually plastic (to reduce noticeable edges) knife.

Knockdown texture reduces construction costs because it conceals imperfections in the drywall that normally require higher more expensive stages of sand and prime for drywall installers.

Knockdown, a drywall texturing technique, is not very challenging and the results are reasonably predictable yet visually interesting. The usual method for applying the texture on ceilings is to spray it on with a hopper gun.

Shred downhill mountain biking. You then scrape over the spray with a drywall knife to 'knock it down' and create a flat, pebbly texture. Regular drywall joint compound, or mud, is generally used to create the knockdown texture. You can use the premixed variety or mix your own. Either way, you must be able to spray the mixture with the hopper gun, so it should be about the consistency of pancake batter or thick paint. Pick up some of the mixture with a drywall knife and turn the knife over. If the mixture doesn't fall off the blade, add more water and keep stirring to thin it out.

After thinning, test the mixture again. Hold the knife upright and horizontal.

If the mixture runs off the blade, add more mud. When the mixture is the right consistency, it won't run off the knife until you tilt the blade at a 30-degree or steeper angle and it won't cling when you turn the knife over.Preparing Joint Compound Powder.